Product Overview 

DORMAKABA® Bottom Patch Fittings are designed to be used with our bottom door pivots or floor closers and fit snugly in the lower corner of the glass panel, requiring a hole and cut-out in the glass. They are available in brushed or polished stainless steel finishes.

Here are the specifications to be aware of:

• 2-3/4" (70 mm) Pivot Setback
• For 3/4" (19 mm) Glass 
• Use Monolithic Tempered Glass

When using this hardware, please adhere to the following guidelines:

• Maximum Height: 102" (2.59 m)
• Maximum Weight: 194 Lbs. (88 kg) 
• Maximum Width: 42" (1.09 m) If the door exceeds any of these limitations, it is recommended to use full door rails.

Glass fabrication requires: One 3/4" (19 mm) Diameter Hole and Corner Notch

These fittings come with a template and instructions and adhere to the following product warning: Not suitable for use with laminated glass.

Furthermore, please note the Stainless Steel Advisory: While stainless steel is resistant to corrosion, it is not rust or stain-proof. It is recommended to perform periodic maintenance to maintain its factory finish. For further details, please refer to the Stainless Steel Disclaimer in the Technical References section below.